I wish I had found a 1/2" ID x 1/4" ID barb fitting to just plug into the drain tube and drain hole, but I couldn't find one anywhere. I'm sure you could also do this with a few elbows as in the other write-up, but it seemed simpler to me to just make a straight adapter instead. It would have been cheaper if I had used plastic/poly parts but I could not find them in the 1/2" diameter. Repeat for the drain tube on the other side of the bed.ĭone and done! All in all it cost me around $20. Place plumbing adapter back into the drain hole in the bed: (Be sure to attach it all the way the picture shows it partially attached for demonstrative purposes): Remove plumbing adapter from the drain hole in the bed and attach to the drain tube. (I measured mine to approximately the top of the coupler): The cover itself lies flush mount, enabling you to improve the appearance of your truck. You can always trim more if necessary, so be sure to err on the side of caution. Fits 2016 - 2022 Toyota Tacoma (fits w/ or w/o bedside storage boxes) 5' 1' Bed (60.5') STYLISH MATTE FINISH The Ultra Flex’s durable aluminum panels come with a matte-black finish. Make sure you have enough slack in the line to ensure it reaches far enough. Measure out an approximate length to trim the drain tube. Place the 1/4" end of the assembled plumbing adapter into the drain hole in the bed: This is the threading on the inside of the fittings.Īssemble the three parts together so they look like this:Īttach drain tube to the drain port on underside of rail: This is the threading on the outside of the fittings.įIP stands for Female Iron Pipe thread. This is the size for the barbed ends of the fittings. - 1/2 in ID x 3/8 in MIP adapter (x2).- 1/4 in ID x 3/8 in MIP adapter (x2).This will be the starting size for your drain tube adapter.īuy the following plumbing parts at your local hardware store (I used Watts brand brass fittings as that is what was available): If you don't know, you can always call UnderCover customer service and they will tell you over the phone. I purchased model FX41003 for my 2013 DCLB and the drain tube is 1/2" in diameter. I want to make sure anyone can do this without having to get a tutorial from their local hardware store employees.*ĭetermine the diameter of your drain tube. *DISCLAIMER: these instructions are written as simple as possible so I apologize if it is too "dumbed down" for some of you. I decided to make a write-up for anyone else who is looking for a quick solution to their drain tube issue but does not want to drill into their bed. So after a few trips to the local Home Depot and some trial and error, I found a simple solution to the problem. It's not a bad write-up, but the pieces are not very distinguishable and the sizes used did not fit on my drain tube. I did some research on TW and found a thread that shows how to re-route the drain into a smaller plumbing barb using some poly elbows found at the hardware store. I recently purchased an UnderCover Flex model FX41003 for my 2013 DCLB and was slightly irritated with UnderCover's expectation that you would drill into your bed in order to accommodate the size of their drain tube.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |